Made-to-Measure Cantilever Walkway Canopy 940mm x 4875mm

The Concept Cantilever Walkway Canopy 940mm x 4875mm is a practical and attractive weather protection solution for walkways, entrances, patios and access areas. Manufactured on a modular basis, the system can be extended in the future if additional coverage is required.

The cantilever design requires no front support posts, leaving the area beneath the canopy clear and unobstructed. This makes it suitable for pedestrian access and everyday use while providing protection from the weather.

The translucent Opal GRP roof panels allow natural daylight to pass through while providing shelter from the elements.

GRP Walkway Canopy Features

• Made-to-measure: Manufactured to the required dimensions.
• Cantilever design: No front support pillars are required.
• Modular system: Can be extended in the future if additional coverage is required.
• Four support beams: Includes four made-to-measure support beams.
• GRP roofing: Translucent Opal roofing sheets manufactured from 3-4mm GRP.
• Colour options: White or Brown beams.
• Low maintenance: Designed to provide long-lasting performance with minimal upkeep.

940mm x 4875mm Walkway Canopy Specification

• Product: Cantilever Walkway Canopy
• Overall size: 940mm x 4875mm
• Maximum projection: 940mm
• Support beams: Four made-to-measure beams
• Maximum support arm height: 320mm
• Roof material: 3-4mm Glass Reinforced Plastic (GRP)
• Roof colour: Opal translucent
• Beam colours: White or Brown

Left-Handed or Right-Handed Beams

The support beams are finished on one side, so please select either left-handed or right-handed beams when ordering.

To determine the handing, imagine you are standing in front of the canopy with your back towards the wall where the canopy will be installed.

Installation Requirements

• A minimum of 500mm clear brickwork is required above the beams.
• If there is less than 500mm of clear brickwork, four bungalow brackets should be ordered.
• No ground preparation is required.
• Planning permission is often not required, although local requirements should always be checked.
• Guttering and fascia boards are not included and can be ordered separately if required.

Walkway Canopies for Entrances and Access Areas

The Concept Cantilever Walkway Canopy is suitable for entrances, pathways, side access routes, patios and sheltered walkways. Its pillar-free design provides weather protection without placing support posts in the area below the canopy.

The system is manufactured on a modular basis, providing the option of extending the canopy in the future where additional coverage is required.

Important Information

GRP products are manufactured to order. Please ensure all measurements and product selections are correct before placing your order. As these products are custom-made, they are non-returnable and cannot be cancelled once production has commenced.

Delivery: These products are delivered on dedicated transport rather than by standard carrier. This helps reduce the risk of damage during transit. Because the dedicated vehicle must be loaded efficiently, delivery times can vary depending on the delivery route and load. You will be contacted with your delivery day before delivery takes place.

Call us for a quote for your made-to-measure cantilever walkway canopy.