Cheltenham GRP Over Door Canopy

The Cheltenham Over Door Canopy combines traditional styling with strong, rigid GRP construction. Its dual-pitch design features a realistic tile-effect finish, lead-look flashing and imitation woodgrain detailing, creating an attractive addition to your entrance.

The tile-effect roof is available in Terracotta or Slate Grey, while the simulated woodgrain fascia and ceiling are available in White, Brown or Light Oak.

Key Features

• Dual-Pitch Design: Traditional canopy styling with a tile-effect roof.
• Tile-Effect Finish: Available in Terracotta or Slate Grey.
• Lead-Look Flashing: Adds traditional detailing to the canopy.
• Imitation Woodgrain Detail: Fascia and ceiling available in White, Brown or Light Oak.
• Strong Rigid GRP: Durable construction designed for long-lasting use.
• Low Maintenance: Requires only occasional washing with warm soapy water.
• Two Projection Options: Available in 730mm or 880mm projection.
• Decorative Options: Available with either Fleur-de-Lys or T-Bar detailing.
• Matching GRP Brackets: BRG7 brackets supplied to match the base colour.
• Fitting Kit Included: Supplied with a comprehensive fitting kit.

Colours & Options

• Tile Effect: Terracotta or Slate Grey
• Fascia & Ceiling: White, Brown or Light Oak
• Projection: 730mm or 880mm
• Decorative Detail: Fleur-de-Lys or T-Bar
• Brackets: BRG7, colour matched to the base

Important Information

The size ordered is the total external size of the canopy.

GRP products are made to order and non-returnable. Please ensure your measurements are correct and that you have selected the right product and options for your requirements before ordering.

Fitting Instructions

1. Find the centre of the door opening and measure the position for the support brackets. The position can vary provided they fit beneath the ends of the base.
2. Fix the brackets level onto the wall using the supplied plugs, screws and cover caps.
3. Position the bottom tray onto the brackets and centralise it with the door opening. Screw it back against the wall and fix the end of each bracket into the tray.
4. Slide the top onto the bottom tray flange and fix it back to the wall through the lead-look upstand at approximately 300mm intervals.
5. Clean off any dust or dirt and seal using a suitable silicone sealant.
6. The installation is now complete.

The Cheltenham canopy requires only occasional washing with warm soapy water to maintain its appearance.

Do not use abrasive or solvent cleaners on this product.

Delivery Information

GRP products are delivered using dedicated transport rather than standard carrier networks. This helps reduce the risk of damage during handling and ensures your canopy arrives in good condition.

Dedicated transport requires deliveries to be planned around efficient vehicle loading, so some deliveries may take longer than others. You will be notified of the delivery day before delivery takes place.

Cheltenham Fitting Guide

Download the Cheltenham Fitting Guide